ROG Ally: Disassembly and Reassembly of D-pad and A/B/X/Y Buttons

 

Capture d’écran 2024-05-07 111004.jpg

Before you begin:

  1. Read the Safety Precautions and Pre-repair Checklist.
  2. Remove the following components:

Bottom

Battery

Fan Module

I/O board (Analog sticks and haptic motors)

• Motherboard

Disassembly

  1. Flip over the motherboard, then remove the D-pad pads and A/B/X/Y pads from the motherboard.

Capture d’écran 2024-05-07 111120.jpg

2. Flip over the display panel module, and the D-pad and A/B/X/Y buttons will fall from the display panel module.

Capture d’écran 2024-05-07 111154.jpg

Reassembly

  1. Align and install the D-pad and A/B/X/Y buttons in the orientation shown in the illustration below.

Capture d’écran 2024-05-07 111327.jpg

2. Align and install the D-pad and A/B/X/Y pads in the orientation shown in the illustration below.
NOTE: Ensure the legs of the pads are all securely inserted through the holes on the motherboard.
3. Install the components you removed in the Before you begin section.

 

Capture d’écran 2024-05-07 111509.jpg

Was this article helpful?
0 out of 0 found this helpful